• Wide body console box (item no. 7160-0894)
• Internal cup holder (item no. 7160-0846)
• 2-inch wide pocket (item no. 7160-0924)

Note: Only the accessories listed above are included in the kit. Items such as control heads, radios, docking stations, motion attachments, computers, toggle switch plates, and locking pocket shown in photos are not included.  ​

Options to consider:

To add your floor plate, click here.

To add your vehicle specific leg kit, click here.

To add a magnetic mic clip, click here.

To add a rail mounted mic clip, click here.

28 lbs. (12.7 kg)

Height: 10.88" (27.6 cm)
Width: 11.83" (30.1 cm)
Depth: 24.75" (2.9 cm)

• Has a consistent mounting space height of 11.5". The included cup holder uses 4.5" (11.43 cm) of that space.
• Designed to house full-sized devices and accessories.
• Has additional side mounting area of 2-inch that will accommodate the pocket (item no. 7160-0924), 2-inch faceplate for switches or power ports or a smaller device.

• Accommodates 5" of mounting space for one to two full-sized devices or faceplates.
• Two 12-volt plug knockouts, located on top passenger side and two knockouts for switches, dual USB power ports, battery voltage display, data/mic jack or USB/AUX input module extension.

• Low profile, universal console with sloped front mounting area.
• Designed to work with top plate/tunnel plate and leg kits.
• Two 12 volt plug knockouts, located on passenger side wall of console box and one knockout for switches, dual USB power ports, battery voltage display, data/mic jack or USB/AUX input module extension.
• PEM’s for mounting mic clip (item no. 7120-0723) on both sides.
• Side vented openings for air flow or mounting a speaker inside the console box.
• PEM’s on back of console box for mounting external cup holder (item no. 7160-0847) and armrest (7160-0429) or printer armrest (item no. 7160-0430).
• Front plate of console underneath the dash area has placement for a power distribution block or Lind shut‐down timer using pre‐configured mounted holes.
• Computer can be center mounted either off‐set towards the passenger on the “smiley face pattern” or on the 3‐bolt pattern closer to the driver for easy articulation access.
• Fully welded construction for long term product life span.
• 3 faceplates and 3 filler panels are included.
• Box ships fully assembled (except for accessories).
• Must order as is. There are no substitutions for accessories. Accessories may need to be assembled.
• Limited Lifetime Warranty.

Resources:

Product Sheet